Microstructure, Isothermal and Thermomechanical Fatigue Behaviour of Leaded and Lead-free Solder Joints

The reliability of solder joints is a critical issue in the microelectronics industry. The requirement of permanent electrical and thermal connections between solder alloys and the various components of a surface mount device is dependent upon the mechanical integrity of the solder and its interfaces. Accordingly, in this paper, the reliability of lead-free, Sn-3.8Ag-0.7Cu, and leaded, Sn-37Pb, solder alloys was investigated under both thermal-mechanical fatigue (TMF) and isothermal mechanical fatigue (IF) conditions. The investigation included material characterisation and fatigue testing on 4-ball grid array (BGA) specimens. The IF tests were carried out under load control at three different temperatures including Room Temperature (RT), 35°C and 75°C. Also, a set of ‘not-in-phase’ (nIP), ‘in-phase’ (IP) and ‘out-of-phase’ (OoP) combined thermal and mechanical cycling tests were carried out to investigate the TMF behaviour of the solders. The stress-life curves for each test condition were generated and then compared taking into account the observations on microstructure. It was found that the IF and TMF performance of Sn-3.8Ag-0.7Cu alloy was better than Sn-37Pb alloy when expressed as stress-life curves. Additionally, the Sn-3.8Ag-0.7Cu was less susceptible to the changes in temperature. This study provides a comprehensive insight into the reliability of solder alloys under a wide range of loading conditions.